C101 Polyaspartic 100% Solids

Brand :

Westcoat

Westcoat EC-101 High-Gloss Polyaspartic Topcoat is similar in performance to the EC-95 High-Gloss Polyurethane Topcoat, but with a much faster cure time. This increased cure time is useful for one-day garage floor installations. For exact specifications on chemical resistance, see the chemical resistance chart on the last page of this datasheet. As you can see, EC-101 offers near-perfect chemical resistance, and far exceeds the demands of residential garage installations.

Categories: Epoxies, Materials, Sealant and Waterproofing Tag: Polyaspartic

Description

EC-101 is a two component, 100% solids, solvent-free, polyaspartic, available in clear and pigmented. EC-101 Polyaspartic is designed to be used as a topcoat for many of the Westcoat Epoxy Systems. It provides a non- yellowing, high gloss, fast drying, high build finish with outstanding wear resistance.

Uses

EC-101 can be used interior or exterior and is specified as the finish coat for use in moderate chemical environments or in moderate traffic areas. EC-101 may be applied over a variety of Westcoat epoxies, such as EC-12 and EC- 34 and can also be applied over TC-60 Color Chips and TC-65 Quartz Sand. EC-101 is also used as a sealer on a variety of other substrates such as plain concrete, Texture-Crete and stained concrete flooring. Use EC-101 on industrial floors, garage floors, decorative floors, restaurant floors, food processing facilities, automotive service areas, airplane hangars, commercial pool decks or where a high build and high sheen is desired.

Advantages

USDA/FDA Compliant • Medium Viscosity • 100% Solids • Chemical Resistant • UV Resistant
High Strength • Low VOC Content • Non-flammable (except when thinning) • Fast-Drying • Heat Resistant

Product Data

Packaging Coverages

VOC Content

2 gal & 10 gal kits available.

~160-400 ft2 / US gal. (Clear) ~200-400 ft2 / US gal. (Pigmented)

Clear: Trace | Pigmented: <50 gm/l

Color Mix Ratio

Shelf Life

Clear & Pigmented 1:1 (By Volume)

2 years in unopened packaging

Inspection

Surface must be structurally sound, dry, and free of laitance, oil, grease, curing agents, dirt, dust or other foreign material that may prevent proper adhesion. When applying EC-101 over an epoxy coating, ensure that the material is properly bonded to the substrate.

Preparation

EC-101 may be applied over Westcoat epoxies, such as EC-12 or EC-34 after the surface is dry to the touch, but no later than 24 hours (@ 72°F). If delay occurs and re-coating exceeds 24 hours, it is recommended that the surface be lightly sanded and wiped with denatured alcohol before applying EC-101. A test area should be performed to verify adhesion when re-coating. For additional information on preparation, please refer to the desired System Specification Sheet for further information regarding Surface Preparation. Surface should be prepared per industry standard.

Mixing

Premix each component separately. In a clean bucket, mix 1 part A with 1 part B, by volume of EC-101. Mix thoroughly with a low speed (400-600 rpm) drill motor for 2-3 minutes. Make sure to scrape the sides and bottom of the container during mixing. After mixing has been completed, promptly remove material from container.

DISCLAIMER: PURCHASER’S SOLE AND EXCLUSIVE REMEDY AGAINST THE MANUFACTURER OF WESTCOAT, SHALL BE LIMITED SOLELY TO THE REPLACEMENT OF ANY DEFECTIVE MATERIAL OR A PAYMENT BY THE MANUFACTURER IN AN AMOUNT EQUAL TO THE COST OF THE ORIGINAL MATERIAL.

EC-101 Polyaspartic Datasheet